Busy. Please wait.
or

show password
Forgot Password?

Don't have an account?  Sign up 
or

Username is available taken
show password

why


Make sure to remember your password. If you forget it there is no way for StudyStack to send you a reset link. You would need to create a new account.
We do not share your email address with others. It is only used to allow you to reset your password. For details read our Privacy Policy and Terms of Service.


Already a StudyStack user? Log In

Reset Password
Enter the associated with your account, and we'll email you a link to reset your password.
Don't know
Know
remaining cards
Save
0:01
To flip the current card, click it or press the Spacebar key.  To move the current card to one of the three colored boxes, click on the box.  You may also press the UP ARROW key to move the card to the "Know" box, the DOWN ARROW key to move the card to the "Don't know" box, or the RIGHT ARROW key to move the card to the Remaining box.  You may also click on the card displayed in any of the three boxes to bring that card back to the center.

Pass complete!

"Know" box contains:
Time elapsed:
Retries:
restart all cards
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.

  Normal Size     Small Size show me how

APU Study IV

APU Study- LM4 (External Power and AIR)

QuestionAnswer
Ensure lower engine bay doors are closed prior to WHAT? APU start
Ensure WHAT switch is set to ALTER and AIR SOURCE ST is set to OFF to prevent ICL coolant overheat AIR SOURCE CREW
APU start time is 15 seconds. If APU does not reach WHAT within 40 seconds (APU run light will illuminate at 95% RPM) start shut down 95% RPM
Engine WHAT can only be powered in 2-min intervals by placing ENG INST TEST switch to LOW or HIGH for approximately 5 seconds SCDU
Ensure WHAT and WHAT are clear of moving surfaces prior to applying hydraulic pressure? People and Equipment
Operate APU a minimum of 30 seconds before coupling to ADG to ensure APU oil pressure and WHAT stabilization EGT
Operate APU a minimum of 5 minutes prior to coupling at temperatures below WHAT? If APUS have been couple within the past 4 hours this is not required 0 degrees
ADG will couple within WHAT at temperatures above 30 degrees 6 seconds
ADG will couple within 20 seconds at temperaures below WHAT? 30 degrees
A minimum of WHAT must have air flowing out. If no flow is detected, terminate APU run and troubleshoot One Cooling Scoop