IA PTI In-Cab Word Scramble
|
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
| Item | Inspecting For: |
| Safety Belt | * Securely mounted * Properly latches * Not ripped, torn or frayed |
| Emergency Equipment | * Fire Extinguisher is securely mounted and fully charged * 3 reflective triangles in passenger side-box * Spare fuses for all circuits that require fuses unless equipped with circuit breakers |
| Safe Start | * Push clutch to the floor * Transmission in NEUTRAL * Turn key to "ON" position * Wait for gauges to cycle * Keep clutch pressed, turn over motor until it starts * Slowly release clutch once engine reaches idling speed |
| Temperature Gauge | * Rises to operating range * Warning light is off |
| Oil Pressure Gauge | * Rises to operating range * Warning light is off |
| Ampmeter / Voltmeter | * Rises to operating range 12-14 volts * Warning light is off |
| Air Pressure Gauge | * Rises to operating range (90-120 PSI) * Warning light is off |
| Lighting Indicators | * Turn on and check the following * Right and left turn indicator * Low, high beam * Four-way/hazard indicators |
| Heater/ Defroster | * All fans speeds work * Nothing blocks the air flow |
| Windshield/ Mirrors | * Mirrors properly adjusted * ALL Glass is clean and has no cracks or damage * Nothing blocking driver's view |
| Windshield Wipers | * Blades securely mounted. Not cracked, dry-rotted or missing. * Proper spring tension to hold to windshield * All speeds work * Windshield washer fluid full and operates properly |
| Parking Brake Check Tug Test for Tractor | *Engine running, air to 90-120 PSI * Release the RED button (push in) * Put truck in 1st gear, gently ease clutch out - feel for resistance * Push clutch back in and reset RED button (pull out) *THAT WAS THE TEST FOR THE TRACTOR PARKING BRAKES |
| Parking Brake Check Tug Test for Trailer | *Engine running, air to 90-120 PSI * Release the YELLOW button (push in) * Put truck in 1st gear, gently ease clutch out feel for resistance * Push clutch back in and reset YELLOW button (pull out) * THAT WAS THE TEST FOR THE TRAILER PARKING BRAKES |
| Service Brake/ABS | * Put truck into 2nd or 3rd gear * At approximately 5 MPH, Apply service brake to stop vehicle * Verify that brakes work properly * Verify that vehicle does not pull to one side or the other * Verify ABS light is off |
| Air Brake Check (Leaks) | * Turn key on (DO NOT START) - Have a minimum of 105 PSI * Release both brakes Y then R - Expect 10-15 PSI loss of air * Wait one minute, you should lose no more than a 3 PSI per min. * Apply service brakes. you should lose no more than 4 PSI per min |
| Air Brake Check (Alarm) | * Leak Check Complete *Start fanning/pumping brakes until you reach about 60 PSI and which time your light and/or warning buzzer will come on. |
| Air Brake Check (Buttons) | * Leak and Alarm Check Complete *Pumping the brakes until you reach approximately 20-40 PSI at which time the spring brakes will set. |
Created by:
NADTA
Popular Standardized Tests sets