100 Q & A
Help!
|
|
||||
---|---|---|---|---|---|
1. (001) What estimated percent of accidents are caused by nature? | show 🗑
|
||||
2. (001) In the operational risk management process, the responsibility for identifying and controlling hazards rests with | show 🗑
|
||||
3. (001) Which safety-training phase is an effective tool that creates a lasting impression for new airman? | show 🗑
|
||||
show | c. person that was issued the tool.
🗑
|
||||
5. (001) The lowest person authorized to clear a red X when a lost tool cannot be located is | show 🗑
|
||||
show | c. green markings.
🗑
|
||||
7. (001) Minimum requirements for positioning of fire extinguishers is listed in | show 🗑
|
||||
show | d. when you’re working on electrical equipment.
🗑
|
||||
9. (002) Fall protection is required when it becomes necessary to perform required tasks where a worker can fall | show 🗑
|
||||
10. (003) Radiation hazards are affected by | show 🗑
|
||||
11. (003) The recommended procedure for cooling an overheated brake assembly is to park the aircraft in an isolated location, then | show 🗑
|
||||
12. (003) Normally, the safe distance behind an operating jet engine exhaust is | show 🗑
|
||||
show | d. Wrap chains around each wheel individually.
🗑
|
||||
show | c. A feeling of emptiness.
🗑
|
||||
15. (004) Any fuel spill not over 50 square feet and not continuous is classified as a | show 🗑
|
||||
16. (004) Individuals who are not directly involved in a nitrogen servicing operation should be outside a | show 🗑
|
||||
show | a. preventive maintenance.
🗑
|
||||
show | c. immediate supervisors.
🗑
|
||||
19. (006) Prime contributors to dropped objects are | show 🗑
|
||||
show | d. collecting, storing, and retrieving base-level data.
🗑
|
||||
21. (007) The basic rules for the maintenance data documentation system are contained in TO | show 🗑
|
||||
22. (008) The three phases of the operational events subsystem of the IMDS CDB are | show 🗑
|
||||
23. (008) You can use the IMDS CDB Training Management Subsystem to monitor | show 🗑
|
||||
show | c. 90.
🗑
|
||||
show | b. a telephone call from the instructor of the student.
🗑
|
||||
26. (010) Tasks that a person is expected to perform in a duty position or workcenter but are not included in the CFETP Part II or AFJQS are listed | show 🗑
|
||||
show | c. MAJCOMs.
🗑
|
||||
show | b. 781F.
🗑
|
||||
show | d. After the IMDS CDB event number is entered at maintenance debriefing.
🗑
|
||||
30. (011) Engine over-temperature conditions are recorded on the AFTO Form | show 🗑
|
||||
31. (011) You would use the AFTO Form 781K to document | show 🗑
|
||||
32. (012) The standards for the entries to be made in the AFTO 781 series forms are specified in the | show 🗑
|
||||
show | c. 20091212.
🗑
|
||||
show | d. Place the statement “Symbol entered in error,” in the discrepancy block and sign the “CORRECTED BY” block.
🗑
|
||||
35. (012) During an aircraft inspection, you find a deteriorated insignia decal. What symbol would you use in the aircraft forms? | show 🗑
|
||||
show | a. One.
🗑
|
||||
show | a. abbreviated TO.
🗑
|
||||
38. (014) Which TCTO is identified by a series of red diagonals alternately spaced with red Xs (X) around the border of the first page? | show 🗑
|
||||
39. (014) As a general rule, ITCTO are replaced by formal TOs within | show 🗑
|
||||
40. (015) The procedures for the entries on an AFTO Form 22 are outlined in | show 🗑
|
||||
41. (015) What type of TO improvement is issued for TCTO deficiencies? | show 🗑
|
||||
show | c. Manual.
🗑
|
||||
show | d. Installation traffic rules.
🗑
|
||||
show | b. numerical sequence.
🗑
|
||||
show | a. a ready reference for determining the progress of the inspection
🗑
|
||||
46. (018) Which inspection is basically a flight preparedness check? | show 🗑
|
||||
show | d. End-of-runway.
🗑
|
||||
show | b. after flights when a turn-around sortie or a continuation flight is scheduled.
🗑
|
||||
49. (018) The basic postflight inspection is performed to | show 🗑
|
||||
50. (018) Which is the most extensive inspection? | show 🗑
|
||||
51. (018) The home station check is accomplished in conjunction with | show 🗑
|
||||
52. (018) What aircraft inspection requires skills, equipment, or facilities not normally possessed by operating locations? | show 🗑
|
||||
53. (018) What symbol is entered on the forms if an aircraft exceeds the programmed depot maintenance cycle by 90 days and an extension is not granted? | show 🗑
|
||||
show | d. Acceptance.
🗑
|
||||
55. (019) Why are aluminum alloy washers used with steel bolts on aluminum alloy parts in lowtorque applications? | show 🗑
|
||||
show | d. Hexhead.
🗑
|
||||
57. (019) Which bolt has a recessed head and is used in high-tension applications? | show 🗑
|
||||
show | b. Two.
🗑
|
||||
59. (019) To use .032 gauge safety wire properly, there should be how many turns per inch? | show 🗑
|
||||
show | d. maximum setting and at least six times.
🗑
|
||||
61. (020) Aircraft cable size is determined by its | show 🗑
|
||||
show | a. 7 strands with 19 wires per strand.
🗑
|
||||
show | a. soft rubber.
🗑
|
||||
show | d. insert a piece of safety wire into the hole in the end of the terminal.
🗑
|
||||
show | a. aluminum-alloy and stainless-steel.
🗑
|
||||
66. (021) Generally, low-pressure hoses are used for pressures of what pounds psi and below? | show 🗑
|
||||
show | d. Pin-and-socket contacts.
🗑
|
||||
show | d. All of the above.
🗑
|
||||
show | d. exhausted or salvaged.
🗑
|
||||
show | c. Intergranular.
🗑
|
||||
show | a. Stress.
🗑
|
||||
show | d. All of the above.
🗑
|
||||
73. (024) The optimum temperature used to cool sealants that were mixed in an automatic mixing machine is | show 🗑
|
||||
show | d. Air isn’t required to affect a cure.
🗑
|
||||
show | c. environmental conditions.
🗑
|
||||
show | c. Detergent cleaners
🗑
|
||||
show | c. Sodium bicarbonate and water.
🗑
|
||||
78. (025) Which statement is not a good lubrication tip? | show 🗑
|
||||
show | d. the required inspection and servicing are complete.
🗑
|
||||
show | a. the aircrew.
🗑
|
||||
81. (026) Which condition is most likely to cause aircraft damage? | show 🗑
|
||||
82. (026) What type of jack would you use to raise an aircraft strut prior to a tire change? | show 🗑
|
||||
83. (027) The F–2 lifting bag is designed to lift | show 🗑
|
||||
84. (027) During crash recovery, what method of aircraft hoisting is confined to emergencies when no other method is available? | show 🗑
|
||||
85. (028) Bench stock levels are established to provide a | show 🗑
|
||||
show | c. Nine.
🗑
|
||||
show | c. AF Form 1297.
🗑
|
||||
88. (028) Critical items are generally small numbers of items that cause the largest number of | show 🗑
|
||||
89. (028) The base critical items list is maintained by | show 🗑
|
||||
show | c. AFTO Form 350.
🗑
|
||||
91. (028) What copy of the DD Form 1348–1 is retained by the individual who receives an item from supply? | show 🗑
|
||||
show | b. AFTO Form 349.
🗑
|
||||
show | d. 1577 and DD Form 1577–1.
🗑
|
||||
show | a. 1577–2 and 1577–3.
🗑
|
||||
95. (029) To report quality deficiencies attributed to errors in workmanship, use a Category | show 🗑
|
||||
96. (029) Submission of a Category II deficiency report is required within how many calendar days? | show 🗑
|
||||
show | b. 100 hours of operation or one year from the date of receipt.
🗑
|
||||
98. (030) A commander assures that property is receiving proper care and is being properly safeguarded by | show 🗑
|
||||
99. (030) What type of responsibility is assumed by an individual who has acquired physical possession of government property? | show 🗑
|
||||
100. (030) When pecuniary liability is not involved, an individual may be relieved of property responsibility | show 🗑
|
Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Created by:
;)
Popular Aviation sets