Upgrade to remove ads
Busy. Please wait.
Log in with Clever
or

show password
Forgot Password?

Don't have an account?  Sign up 
Sign up using Clever
or

Username is available taken
show password


Make sure to remember your password. If you forget it there is no way for StudyStack to send you a reset link. You would need to create a new account.
Your email address is only used to allow you to reset your password. See our Privacy Policy and Terms of Service.


Already a StudyStack user? Log In

Reset Password
Enter the associated with your account, and we'll email you a link to reset your password.

IA DOT Pretrip InCab Inspection

        Help!  

Item
Inspecting For:
Safety Belt   * Securely mounted * Properly latches * Not ripped, torn or frayed  
🗑
Emergency Equipment   * Fire Extinguisher is securely mounted and fully charged * 3 reflective triangles in passenger side-box * Spare fuses for all circuits that require fuses unless equipped with circuit breakers  
🗑
Safe Start   * Push clutch to the floor * Transmission in NEUTRAL * Turn key to "ON" position * Wait for gauges to cycle * Keep clutch pressed, turn over motor until it starts * Slowly release clutch once engine reaches idling speed  
🗑
Temperature Gauge   * Rises to operating range * Warning light is off  
🗑
Oil Pressure Gauge   * Rises to operating range * Warning light is off  
🗑
Ampmeter / Voltmeter   * Rises to operating range 12-14 volts * Warning light is off  
🗑
Air Pressure Gauge   * Rises to operating range (90-120 PSI) * Warning light is off  
🗑
Lighting Indicators   * Turn on and check the following * Right and left turn indicator * Low, high beam * Four-way/hazard indicators  
🗑
Heater/ Defroster   * All fans speeds work * Nothing blocks the air flow  
🗑
Windshield/ Mirrors   * Mirrors properly adjusted * ALL Glass is clean and has no cracks or damage * Nothing blocking driver's view  
🗑
Windshield Wipers   * Blades securely mounted. Not cracked, dry-rotted or missing. * Proper spring tension to hold to windshield * All speeds work * Windshield washer fluid full and operates properly  
🗑
Parking Brake Check Tug Test for Tractor   *Engine running, air to 90-120 PSI * Release the RED button (push in) * Put truck in 1st gear, gently ease clutch out - feel for resistance * Push clutch back in and reset RED button (pull out) *THAT WAS THE TEST FOR THE TRACTOR PARKING BRAKES  
🗑
Parking Brake Check Tug Test for Trailer   *Engine running, air to 90-120 PSI * Release the YELLOW button (push in) * Put truck in 1st gear, gently ease clutch out feel for resistance * Push clutch back in and reset YELLOW button (pull out) * THAT WAS THE TEST FOR THE TRAILER PARKING BRAKES  
🗑
Service Brake/ABS   * Put truck into 2nd or 3rd gear * At approximately 5 MPH, Apply service brake to stop vehicle * Verify that brakes work properly * Verify that vehicle does not pull to one side or the other * Verify ABS light is off  
🗑
Air Brake Check (Leaks)   * Turn key on (DO NOT START) - Have a minimum of 105 PSI * Release both brakes Y then R - Expect 10-15 PSI loss of air * Wait one minute, you should lose no more than a 3 PSI per min. * Apply service brakes. you should lose no more than 4 PSI per min  
🗑
Air Brake Check (Alarm)   * Leak Check Complete *Start fanning/pumping brakes until you reach about 60 PSI and which time your light and/or warning buzzer will come on.  
🗑
Air Brake Check (Buttons)   * Leak and Alarm Check Complete *Pumping the brakes until you reach approximately 20-40 PSI at which time the spring brakes will set.  
🗑


   

Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
 
To hide a column, click on the column name.
 
To hide the entire table, click on the "Hide All" button.
 
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
 
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.

 
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.

  Normal Size     Small Size show me how
Created by: NADTA
Popular Standardized Tests sets