click below
click below
Normal Size Small Size show me how
AIRFRAME 13
Aircraft Electrical Systems
Question | Answer |
---|---|
What type of circuit breaker should not be used in aircraft? | Automatic reset-type circuit breakers |
When should a switch be derated from its nominal rating? | When used with high rush-in circuits, inductive circuits, and direct current motors |
Where is the white position / navigation light mounted? | On the tail, visible from the rear |
What color is a left wing tip position light? | Red |
What factors are considered when selecting wire size for electrical power? | Allowable power loss, permissible voltage drop, and current carrying ability |
When do D.C. motors draw several times their rated current? | When starting |
How long should boning jumper wires be? | As short as possible |
What hardware is used to make bonding or grounding connections to a structure of dissimilar metals? | A washer of suitable material should be used so that corrosion will occur on the washer |
What should be done to a conduit end when fittings are not used? | It should be deburred to prevent wire insulation damage |
What size electrical conduit should be used? | Twenty-five percent larger than the maximum diameter of the wire bundle |
When is circuit breaker designed to open? | When an overload or circuit fault exisists |
What controls the output voltage of an alternator? | A Generator Control Unit (GCU) |
How many terminal lugs can be put on a single terminal strip in an aircraft? | Four |
How can a particular wire in a bundle be identified? | By the identification code on the wire |