click below
click below
Normal Size Small Size show me how
Eng. Cooling Sys.
FAA AMP
Question | Answer |
---|---|
the component(s) in a turbine engine that operate(s) at the highest temperature is/are the | first stage turbine nozzle inlet guide vanes |
which statement is true regarding the air passing through the combustion section of a jet engine? | most is used to engine cooling |
cracks in cooling fins that do not extend into the cylinder head | may be repaired by removing the affected area and contour filling within limits |
what is the purpose of an augmenter used in some reciprocating engine exhaust systems? | to aid in cooling the engine |
(1) some aircraft exhaust systems include an augmenter system to draw additional air over the engine for cooling. (2) augmenter systems are used to create a low pressure area at the lower rear of the aircraft engine cowling regarding the above | Both are true |
what is the function of a blast tube as found on aircraft engines? | a device to cool an engine accessory |
a bent cooling fin on an aluminum cylinder head should be | left alone if no crack has formed |
a broken cooling fin on a cylinder head | may be filed to smooth contours if damage and/or repair limits are not exceeded |
the position of the cowl flaps during normal cruise flight conditions is | closed |
during ground operations of an engine, the cowl flaps should be in what position? | fully opened |
prolonged idling of an engine will usually result in | foreign material buildup on spark plugs |
the most common method and generally the best conduction of heat from the inside of a cylinder barrel to the cooling air is accomplished by | machining fins directly on the outside of the barrel |
an engine becomes overheated due to excessive taxiing or improper ground runup. prio to shutdown, operation must continue until cylinders have cooler, by running engine at | idle RPM |
increased engine heat will cause volumetric efficiency to | decrease |
generally, a small crack just started in a cylinder baffle | may be stop drilled |
the primary purpose of baffles and deflectors installed around cylinders of air-cooled aircraft engines is to | force cooling air into close contact with all parts of the cylinders |
where are cooling fins usually located on air-cooled engines? | cylinder head, cylinder barrel, and inside the piston |
reciprocating engines used in helicopters are cooled by | a fan mounted on the engine |
which of the following results in a decrease in volumetric efficiency? | part-throttle operation |
during an operational check of an electrically powered aircraft engine cowl flap system, the motor fails to operate. which of the following is the first to be checked? | flap actuator motor circuit breaker |
which of the following defects would likely cause a hot spot on a reciprocating engine cylinder? | too much cooling fin area broken off |
high cylinder head temperature are likely to result from | a very lean mixture at high power settings. |
aircraft reciprocating engine cylinder baffles and reflectors should be repaired as required to prevent loss of | cooling |
how do cowl flaps aid in cooling horizontally opposed aircraft engines? | controls the amount of air flowing around the cylinders |
the purpose of an intercooler when ised with a turbocharger is to cool | air entering the carburator from the turbocharger |
cylinder head temperature are measured by means of an indicator and a | thermocouple sensing device |
What part of an air-cooled assembly has the greatest fin area per square inch? | exhaust valve port |
the undersides of pistons are frequently finned. the principal reason is to | provide for greater heat transfer to engine oil |
which of the following should a mechanic consult to determine the maximum amount of cylinder colling fin that could be removed when cracks are found? | engine manufacturer's service pr pverhaul manual |
the greatest portion of heat generated by combustion in a typical aircraft reciprocating engine is | carried out with the exhaust |
what is the position of the cowl flaps during engine starting to warmup operations under normal conditions? | full open at all times |
which of the following assists in removing heat from the metal walls and fins of an air-cooled cylinder assembly? | a baffle and cowl arrangment |