click below
click below
Normal Size Small Size show me how
Ice and Rain control
Ice and Rain control sys
Question | Answer |
---|---|
what system component aids in the prevention of carburator icing? | alcohol injection nozzle |
what is the purpose of the oil seperator in the pneumatic deicing system? | to prevent the deicer boots from oil deterioration |
what is the source of pressure for inflating deicer boots on reciprocating engine aircraft? | vane-type pump |
what icing condition may occur when there is no visible moisture present? | carburator ice |
what is used as a temperature-sensing element in an electrically heated windshield? | thermistor |
what mixture may be used as a deicing fluid to remove frost from an aircraft surface? | ethylene glycol and isopropyl alcohol |
what may be used to clean deicer boots? | soap and water |
two possible sources of heat for the operation of a wing thermal anti-acing system are | compressor bleed air and aircraft electrical systems |
what is one check for proper operation of pitot-static tube heater after replacement? | ammeter reading |
what should be used to melt the ice in a turbine engine if the compressor is immobile because of ice | hot air |
what is the purpose of the distributor valve in the deicing system utilizing deicer boots? | to sequence the deicer boots inflations symmetrically |
some aircraft are protected against airframe icing by heating the leading edges of the airfoil and intake ducts. When is this type of anti-ice system usually operated during flight? | whenever icing conditions are first encountered or expected to occur |
what maintains normal windshield temperature control in an electrically heated windshield system? | thermistors |
where are the heating elements located on most aircraft with electrically heated windshields? | laminated on the glass |
which of the following are found in a laminated integral electrically heated winshield system? | autotransformer, heat control relay, heat control toggle switch, and indicating light |
why should a chemical rain repellant not be used on a dry windshield? | it will restric visibility. |
what is the principle characteristic of a windshield pneumatic rain removal system? | an air blast forms a barrier that prevents raindrops from stricking the windshield surface |
prior to installation of a pneumatic surface-bonded type deicer boots, on the leading edge of the wing, you should | remove all paint from the area to be covered by the deicer boot |
arcing in an electrically heated windshield panel usually indicates a breakdown in the | conductive coating |
how do deicer boots help remove ice accumulations? | by breaking up ice fromations |
why are the tubes in deicer boots alternately inflated? | alternate inflation of deicer boot tubes keeps disturbance of the airflow to a minimum |
which of the following is the best means to use when removing wet snow from an aircraft? | a brush or squeege |
which of the following connects a vacuum to the deicer boots when the system is not in operation, to hold the boots tightily against the leading edges in flight? | distributor valve |
what are the three methods of anti-icing aircraft windshields? | an electric heating element in the windshield, a heated air circulating system, and windshield wipers and anti-acing fluid |
which of the following indications occur during a normal operational check of a pneumatic deicer system? | fluctuating readings on the pressure guage and relatively steady readings on the vacuum guage |
what controls the inflation sequence in a pneumatic deicer boot system? | distributor valve |
which of the following regulates the vacumm of the air pump to hold the deicing boots deflated when the pneumatic deicing system is off? | suction relief valve |
what method is usually employed to control the temperature of an anti-acing system using surface combustion heaters? | thermo-cycling switches |