Fuel Metering
Quiz yourself by thinking what should be in
each of the black spaces below before clicking
on it to display the answer.
Help!
|
|
||||
---|---|---|---|---|---|
show | Mixture control position
🗑
|
||||
How is the fuel control adjusted when trimming a turbine engine? | show 🗑
|
||||
How does an EEC obtain the most effective engine operation? | show 🗑
|
||||
What is generally turned off when trimming an engine> | show 🗑
|
||||
What causes the automatic mixture control to respond in reciprocating engines? | show 🗑
|
||||
What is the fuel metering force of a conventional float-type carburetor in its normal operating range? | show 🗑
|
||||
show | Rich at rated power
🗑
|
||||
How would you adjust the level of the float in a float-type carburetor? | show 🗑
|
||||
How would you achieve better fuel vaporization and control of fuel discharge, especially at lower engine speeds? | show 🗑
|
||||
show | By varying the pressure acting on the fuel in the float chamber
🗑
|
||||
What occurs when a back-suction type mixture control is placed in IDLE CUTOFF? | show 🗑
|
||||
show | by the inclusion in the carburetor of a spring in the unmetered fuel chamber
🗑
|
||||
If the bellows of the automatic mixture control (AMC) in a pressure carburetor ruptures while the engine is operating at altitude, how will the mixture be affected? | show 🗑
|
||||
show | the edge of the float
🗑
|
||||
What component measures the amount of air delivered to the engine? | show 🗑
|
||||
If the engine is not running and the carburetor leaks fuel, what is the likely cause? | show 🗑
|
||||
From where is fuel discharged during idling speeds on a float-type carburetor? | show 🗑
|
||||
show | Velocity increases, temperature decreases, and pressure decreases
🗑
|
||||
The carburetor venturi does not do what? | show 🗑
|
||||
show | By introducing low pressure (intake manifold) air into the float chamber
🗑
|
||||
What is the primary purpose of an air bleed in a float-type carburetor? | show 🗑
|
||||
Where is the measurement usually made to determine the float level in a float-type carburetor? | show 🗑
|
||||
show | mixture control
🗑
|
||||
show | throttle valve
🗑
|
||||
show | air velocity
🗑
|
||||
show | All RPM's above idle range
🗑
|
||||
What is the purpose of the carburetor accelerating system? | show 🗑
|
||||
What carburetor component actually limits the desired maximum airflow to the engine at full throttle? | show 🗑
|
||||
What will happen to the mixture on a carburetor without an automatic mixture control as you ascent to altitude? | show 🗑
|
||||
show | With the engine warmed up and operating
🗑
|
||||
show | The idling air bleed
🗑
|
||||
show | No wind and low moisture
🗑
|
||||
show | At rated power and at idle
🗑
|
||||
show | Changes in RPM or manifold pressure
🗑
|
||||
When the mixture control is moved to IDLE CUTOFF, the manifold pressure decreases and RPM increases momentarily before the engine stops. What does this indicate? | show 🗑
|
||||
When checking the idle mixture on a carburetor, how much of an increase in RPM should there be if the idling mixture is correct? | show 🗑
|
||||
show | The engine will not idle
🗑
|
||||
show | Increase engine power and control detonation and preignition
🗑
|
||||
What will an excessively lean fuel/air mixture cause? | show 🗑
|
||||
show | 1 part fuel to 11 parts air
🗑
|
||||
show | The economizer system
🗑
|
||||
show | Drains the engine manifold lines to prevent fuel boiling
🗑
|
||||
show | humidity
🗑
|
||||
What position will the pressurization and dump valves be in when the engine is shut down? | show 🗑
|
||||
What would a ruptured balance diaphragm cause? | show 🗑
|
||||
What occurs when the air/fuel mixture burns too fast? | show 🗑
|
||||
When should the needle valve and seat be replaced? | show 🗑
|
||||
When operating a gas turbine engine fuel control unit, what factor is NOT used? | show 🗑
|
||||
show | Cams, springs, and linkages
🗑
|
Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Created by:
Ms.Fietzek
Popular Aviation sets