Communications; IFS
Quiz yourself by thinking what should be in
each of the black spaces below before clicking
on it to display the answer.
Help!
|
|
||||
|---|---|---|---|---|---|
| An operable 4096-code transponder with automatic altitude reporting equipment is required in | Class B airspace and within 30 miles of the Class B primary airport.
🗑
|
||||
| You (Tiger 32) are at UKLID for a South arrival from Area 4. You have heard a couple of Tigers calling Tower. You hear the following from Tower: "Tiger (unintelligible), proceed directly to initial Runway 26L". What action should you take? | What a few seconds to see if another Tiger responds. If nobody responds, reply only with "Tiger 32 say again".
🗑
|
||||
| On initial contact with Departure, give the Departure controller the following information: | "Denver Departure, Tiger 23 five thousand three hundred climbing eight thousand five hundred, South Departure, Area 4."
🗑
|
||||
| Basic radar service in the terminal radar program is best described as | safety alerts, traffic advisories, and limited vectoring to VFR aircraft.
🗑
|
||||
| An ATC radar facility issues the following advisory to a pilot flying north in a calm wind: "TRAFFIC 9 O'CLOCK, 2 MILES, SOUTHBOUND..." Where should the pilot look for this traffic? | West
🗑
|
||||
| Which procedure is recommended to ensure that the emergency locator transmitter (ELT) has not been activated? | Monitor 121.5 before engine shutdown.
🗑
|
||||
| When an ATC clearance has been obtained, no pilot in command may deviate from that clearance unless that pilot obtains an amended clearance. The one exception to this regulation is | an emergency.
🗑
|
||||
| An ATC clearance provides | authorization to proceed under specified traffic conditions in controlled airspace.
🗑
|
||||
| Absence of the sky condition and visibility on an ATIS broadcast indicates that | the ceiling is at least 5.000 feet and visibility is 5 miles or more.
🗑
|
||||
| When you are issued a hold short instruction | You are required to read-back the instruction.
🗑
|
||||
| If Air Traffic Control advises that radar service is terminated when the pilot is departing Class C airspace, the transponder should be set to code | 1200
🗑
|
||||
| If you are unsure of your taxi clearance, you should | Hold your position and ask for clarification.
🗑
|
||||
| From whom should a departing VFR aircraft request radar traffic information during ground operations? | Ground control, on initial contact.
🗑
|
||||
| When operating under VFR below 18.000 feel MSL, unless otherwise authorized, what transponder code should be selected? | 1200
🗑
|
||||
| After landing at a tower-controlled airport, when should the pilot contact ground control? | When advised by the tower to do so.
🗑
|
||||
| When activated, an Emergency Locator Transmitter (ELT) transmits on | 121.5 and 243.0 MHz
🗑
|
||||
| The Garmin GNS 430 moving map (Nav page 2) displays the range in nautical miles. You notice the characters "-2" immediately following the range indication. This indicates | The declutter mode that is currently selected, which will remove local waypoints from the moving map display.
🗑
|
||||
| All inbound aircraft to a nontowered airport should continuously monitor the CTAF from a distance of ____ miles. | 10
🗑
|
||||
| If instructed by ground control to taxi to Runway 9, the pilot may proceed | to the next intersecting runway where further clearance in required.
🗑
|
||||
| When should pilots state their position on the airport when calling the tower for takeoff? | When departing from a runway intersection.
🗑
|
||||
| When an air traffic controller issues radar traffic information in relation to the 12-hour clock, the reference the controller uses is the aircraft's | ground track.
🗑
|
||||
| The correct method of stating 10,500 feet MSL to ATC is | "One Zero Thousand, Five Hundred"
🗑
|
||||
| An ATC radar facility issues the following advisory to a pilot during a local flight: "TRAFFIC 2 O'CLOCK, 5 MILES, NORTHBOUND". Where should the pilot look for this traffic? | Between directly ahead and 90 degreed to the right.
🗑
|
||||
| When making routine transponder code changes, pilots should avoid inadvertent selection of which codes? | 7500, 7600, 7700
🗑
|
||||
| If the aircraft's radio fails, what is the recommended procedure when landing at a controlled airport? | Observe the traffic flow, enter the patter, and look for light signals from the tower.
🗑
|
||||
| A non-towered airport lies within the controlled airspace of a towered airport. According to regs, two-way radio communications with ATC are required for landing clearance at | the towered airport only, as well as to fly through the area.
🗑
|
||||
| The correct method of stating 4,500 feet MSL to ATC is | Four thousand five hundred
🗑
|
||||
| Automatic Terminal Information Service (ATIS) is the continuous broadcast of recorded information concerning | noncontrol information in selected high-activity terminal areas.
🗑
|
||||
| TRSA Service in the terminal radar program provides | sequencing and separation for participating VFR aircraft.
🗑
|
||||
| When should pilots decline a land and hold short (LAHSO) clearance? | When it will compromise safety.
🗑
|
||||
| Entering the Training Area through a lateral boundary, when should you announce on Tiger Traffic, "Tiger ___, entering area ____."? | Just prior to penetrating the lateral confines of the Training Area.
🗑
|
||||
| While using the Garmin 430 you accidently end up in a page that you do not want to be in. How can you quickly get back to the map page? | Press and hold the "CLR" button until the NAV chapter page one comes up, then turn the small knob on the right side one click to the right.
🗑
|
||||
| Unless otherwise authorized, two-way radio communications with Air Traffic Control are required for landings or takeoffs | at all tower controlled airports regardless of weather conditions.
🗑
|
Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Created by:
mscourt