Question | Answer |
Parts of a syringe | Tip (MBS), barrel, and inner core plunger (MBS) |
Parts of a needle | Hub, bevel, heel, lumen (inside dimension of needle), gauge(larger the gauge smaller the opening), and length |
Single dose containers | Ampules and syringes
Vials that do not contain preservatives |
Multiple dose containers | Aerosol cans and vials that contain preservatives |
What is a spike? | Used to puncture the rubber diaphragm located inside admin. set |
What is a drip chamber? | Used to calculate the rate at which the solution is being infused |
What is a Roll clamp? | Used to regulate the rate of infusion |
What is a Additive Port? | Used to add medication to the admin. set which will be pushed into vein |
What is a needle adaptor? | Used to connect the admin. set to the catheter |
What is a Filter Device? | Used to prevent the intro. of particulate matter |
What does a prefilter? | Pulls room air into the hood; removes dust, lint, and other large contaminants are removed |
How often must a prefilter be checked/cleaned/changed? | Monthly basis |
What is a HEPA Filter? | High efficiency particulate air filter; removes particulates and microorganisms from the air that are .7 microns and larger |
What doesn't the HEPA filter remove? | Vapors or gases |
Where is the HEPA filter located? | At the back of the hood facing the preparer on the horizontal airflow hood |
How often must the HEPA filter be checked? | Every 6 months |