Help
Options
Didn't know it?
click below
click below
Knew it?
click below
click below
Don't Know
Remaining cards (0)
Know
retry
shuffle
restart
0:00
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Haircutting study
| Question | Answer |
|---|---|
| In a haircut, design lines that are proportionate are established by using? | reference points |
| The highest point on the top of the head is called the? | Apex |
| The bone that protrudes at the base of the skull is the? | Occipital bone |
| The two front corners represent the widest points in the? | Fringe (bangs) area |
| The area between the apex and the back of the parietal ridge is the? | Crown |
| The fringe (bangs) area, when combed into natural falling position, falls no farther than? | The outer corners of the eyes |
| The angle or degree in which a subsection of hair is held from the head when cutting is called? | elevation |
| The section of the hair that determines the length of the hair will be cut is called the? | Guideline |
| A guideline that moves with you as you work through the haircut is a? | Traveling guideline |
| As it dries, curly hair shrinks by | 1/2 inch to two inches |
| Hair texture is based on the? | Diameter of each hair strand |
| In general, the hand that does most of the work in haircutting is the? | Cutting hand |
| When combing the hair during a haircut, it is necessary to? | Palm the shears |
| The fine teeth of the styling comb are used to? | Comb the subsection before cutting |
| The amount of pressure applied when combing and holding a subsection of hair is called? | Tension |
| A layered haircut can be created with? | A traveling guide or stationary guide |
| When cutting uniform or increasing layers, the hand positon used most often is? | Cutting over the fingers |
| A good safety and sanitation measure is to sweep up cut hair and dispose of it before ______ | Blow-drying the clients hair |
| The blade in your razor should be replaced: | Prior to each new client |
| The blunt haircut is also referred to as the: | Zero-elevation cut |
| The graduatied haircut is most commonly cut with an elevation of _______degrees | 45 |
| A long layered haircut is cut at a______degree angle | 180 |
| Checking the length of a haircut by parting the hair the opposite way from which you cut is called? | cross-checking |
| If you use vertical partings in a haircut, you should cross-check the lengths with? | horizontal partings |
| The fringe area is approximately between the | outer corners of the eyes |
| When using the shears-over-comb technique the comb is held | at an angle to the head |
| The process of removing excess bulk without shortening the length is called: | Texturizing |
| Facial Hair is very _____ | coarse |
Created by:
Cosmo Nelly