click below
click below
Normal Size Small Size show me how
Microscope test
| How much does the low power objective contain | 4x |
| How much does the medium power objective contain | 10x |
| How much does the high power objective contain | 40x |
| How much does the eyepiece magnifying lens contain | 10x |
| What part of the microscope is used to hold the microscope when it is being carried. | The arm and the base |
| What part of the microscope is a flat platform where the specimen slides are placed for viewing. | The stage |
| What part of the microscope are clips used to hold the specimen slides in place. | Stage clips |
| What part of the microscope is used to provides light to better see the specimen. | The light source |
| What part of the microscope is the bottom of the microscope that is used for support. | The base |
| What part of the microscope used to control the amount of light that passes through the stage. | The Diaphragm |
| What part of the microscope contains the lens that you look through. This lens is typically 10x. | The eye piece |
| Which part of the microscope moves the stage up and down by large amounts to bring the specimen into focus. | The Coarse Adjustment Knob |
| Which part of the microscope moves the stage up and down by much smaller amounts to fine-tune focus and increase the detail of the specimen. | Fine Adjustment Knob |
| Which part of the microscope has the three lenses that can be rotated to change the magnification. (4x, 10x and 40x) | Low Power, Medium Power and High power objectives |
| Which part of the microscope connects the eyepiece lens to the objective lens. | The body tube |
| Which part of the microscope holds the objective lenses. Can be rotated to change the magnification level. | The revolving nosepiece |
| How should you hold the microscope | With two hands, one on the arm and one on the base. |
| Should the microscope be on a tilted surface? | The microscope is on a flat surface and away from the edge of the table. |
| Where are you supposed to look when changing the objectives? | Always Look to the side when changing objectives and rotate carefully. |
| Which power do you use first? | Always use low (scanning) power first. |
| Should I use the Coarse Adjustment knob on high power? What might it cause? | NEVER use the coarse adjustment knob at high power, it may cause a collision. |
| What are the steps when you are done using your microscope | Always store the microscope with lowest power objective in place, move stage down. TURN LIGHT OFF!!!! |
| What do you clean the lens with? | Only use lens paper for cleaning |