Save
Busy. Please wait.
Log in with Clever
or
show password
Forgot Password?
Don't have an account?  Sign up 
Sign up using Clever
or
Username is available taken
show password

Your email address is only used to allow you to reset your password. See our Privacy Policy and Terms of Service.

Already a StudyStack user? Log In

Reset Password
Enter the associated with your account, and we'll email you a link to reset your password.

Question

What is the MK-16 Mod 0 Max depth?
click to flip
focusNode
Didn't know it?
click below
 
Knew it?
click below
Don't know

Question

Is the use of a T-Bit authorized for normal diving operations?
Remaining cards (18)
Know
0:00
edit
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.

  Normal Size     Small Size show me how

MK-16 Mod 0/1

MK-16 Mod 0/1 Tech Man & Ch 17 &18 of Dive Man

QuestionAnswer
What is the MK-16 Mod 0 Max depth? The Max Depth for MK-16 Mod 0 is 200 FSW when using HeO2 (84/16), and 150 FSW when using Air (N2O2).
Is the use of a T-Bit authorized for normal diving operations? No. The use of a FFM is required during normal MK-16 diving operations.
What factors affect CO2 absorbent duration? Operating temperature and depth directly affect CO2 absorbent performance.
What is the PPO2 Set Point for Mod 0? The Mod 0 Set point is .75.
How often should a MK-16 diver perform a MK-16 dive to maintain his qualification? A MK-16 Diver is required to make a MK-16 dive once every six months to maintain his qualification.
How much pressure is required to drive the reducer? A reserve pressure of 500 PSI is required to drive the reducer.
Min and Max Canister duration? Maximum Canister duration is 300 minutes. Minimum canister duration is 100 minutes. Chart can be found in Dive Man Rev 6 17-11.
What are the general Diving equipment requirements for MK-16 diving operations? General Requirements for MK-16 Diving: 1. Motorized Safety Boat. 2. Two-Way Radios 3. Flash light 4. Dive Flags 5. >2 quarts fresh water in case of chemical injury.
What are the Equipment requirements for a MK-16 Dive Supervisor? Minimum equipment for MK-16 Dive Supervisor are: 1. Dive Watch 2. Dive Bill 3. Air 'D' Tables 4. MK-16 Dive Tables 5. Recall device
When is a Recompression chamber required on the dive station for MK-16 Diving Operations? A recompression chamber is only required when exceeding the max working limit.
What is the maximum descent rate for MK-16? 60 FPM is the Max Descent Rate for MK-16 diving.
Is Surface decompression authorized for MK-16 Diving Operations? Surface decompression is not authorized for MK-16 Diving Operations.
How often is LO-MU Certification performed? LO-MU certification is performed a minimum of every five years.
What documentation is required in a MK-16 Rig Jacket? At a minimum, a Rig Jacket should include the following: 1. A Pedigree Report (detailing serialized components) 2. Certification Letter 3. Maintenance Log 4. Most Recent Initial and predive.
When is an Initial Setup Required? An Initial Setup is required after any repair, any sensor is replaced or repositioned, and/or every six months.
What is the PPO2 Setpoint for MK 16 Mod 1? .75 and 1.3
When does the MK-16 Mod 1 Transition? The Mod 1 transitions from .75 to 1.3 ata at approximately 33 FSW on descent. On ascent, the transition occurs at approximately 13 FSW.
When deploying the EBS for MK-16 Mod 1 Diving Operations, what depth is the EBS initially lowered to? The EBS is lowered to 40 FSW to allow the rig to transition from .75 to 1.3 ata.
Name three ways to reduce Pulmonary or CNS Oxygen Toxicity during multi day diving. 1. Limit dive time to 4-hours per day. 2. Limit dive time to 16 hours per week 3. Conduct shallower dive in .75 ata mode (when using Mod 1)
Created by: NEDUFCPOA
 

 



Voices

Use these flashcards to help memorize information. Look at the large card and try to recall what is on the other side. Then click the card to flip it. If you knew the answer, click the green Know box. Otherwise, click the red Don't know box.

When you've placed seven or more cards in the Don't know box, click "retry" to try those cards again.

If you've accidentally put the card in the wrong box, just click on the card to take it out of the box.

You can also use your keyboard to move the cards as follows:

If you are logged in to your account, this website will remember which cards you know and don't know so that they are in the same box the next time you log in.

When you need a break, try one of the other activities listed below the flashcards like Matching, Snowman, or Hungry Bug. Although it may feel like you're playing a game, your brain is still making more connections with the information to help you out.

To see how well you know the information, try the Quiz or Test activity.

Pass complete!
"Know" box contains:
Time elapsed:
Retries:
restart all cards