click below
click below
Normal Size Small Size show me how
Ch. 10 Tools Week 2
Question | Answer |
---|---|
allen wrench | used to remove or install hex socket-head screws |
torque wrench | used to tighten threaded fasteners to a specific torque setting |
off set screwdriver | used in tight situations where length of regular screwdriver is prohibited |
ball peen hammer | useful for tapping things into place, one side is flat while the other is round |
pliers | tool used for gripping , bending, and pulling |
standard screw driver | used to remove screws that have a slotted recessed head |
retaining ring pliers | made from spring steel and must be installed and removed with these |
center punch | hardened steel points and are used to make depressions in metal surfaces before drilling |
prick punch | used to make a very small depression prior to using the center punch to enlarge the depression for drilling |
pin punch | are various diameters and lengths and are available for driving straight pins, tapered pins, and roll pins in and out of holes. |
drift punch | tapered and are used to align holes in mating parts, allowing a bolt or pin to be passed through the parts |
cold chisel | cutting tool that can shear bolts, pins, rivets, sheet metal, rods, and other materials |
gear puller | used for pulling gears and bearings from shafts |
vise | extremely useful for holding parts while they are being worked on |