MD-11 Air Systems Word Scramble
|
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
| Question | Answer |
| Trim Air provided by which systems | Systems 1 and 3 |
| Trim Air Switch controls | Both Trim Air Pressure Regulating Valves (PRV) |
| Temp Control Knobs control | Trim Air Modulating Valves |
| Trim Air Manifold is routed through | Avionics Bay |
| External air can be connected to | Systems 1 & 2 (Left Side) |
| Conditioned air can be connected to | Right side of AC |
| Avionics Cooling begins when | AC Power Application |
| Number of cooling fans in Avionics and CAC | 3 each (only one runs at a time) |
| On T/O the Avionics Exhaust Fan is ___ and the Venturi is _____ | Exhaust Fan ON, Venturi CLOSED for TO |
| After T/O the Avionics Exhaust Fan is ____ and the Venturi is ____ | Exhaust Fan OFF, Venturi OPEN @ 1.5 PSI differential |
| "FLOW" light in AVNCS FAN switch on means (CPA) | Cooling airflow insufficient, Pressurization airflow insufficient, Altitude (cabin) >10,000' |
| "OVRD" light in AVNCS FAN switch always means | Exhaust Fan is ON, Venturi is CLOSED (comes on for normal takeoff) |
| Air System Test is initiated by | Annunciator Lights Test |
| Air System Test test the following (TEMAC) | Trim air shut-off Engine 2 anti-ice duct Manifold fail detect syst Avionics Fan CAC fans |
| "CAB ALT" light means | >10,000' CA in AUTO or MAN and turns off ECON |
| "NO MASKS" light means | Masks in lav didn't drop by 14,770' Hold switch 3 sec to drop masks |
| Does the Trim Air switch work in auto or manual mode | Both |
| "AVNCS OVHT" light in Trim Air Switch means and does what | Assumes leak in trim air manifold Closes both Trim Air PRVs in AUTO or MANUAL |
| CABIN AIR switch when pressed does what | 1. Reduces to single pack operation 2. Closes Cargo Zone Cond. Air S/O Valve (in MAN, requires QRH to accomplish) |
| Pack "FLOW" light illuminated means | Pack commanded on & low airflow Pack commanded off & flow present |
| 1-2 or 1-3 ISOL switch "DISAG" light means | Valve not in commanded position |
| Limitation on use of 1-2/1-3 ISOL switch | Do not interconnect two or more active engine pneumatic supply systems |
| "USE ENG AIR" light switch on means | A/C is pressurized in flight and APU AIR is selected ON |
| "PRESS" light in PRV switch means | Low Pressure |
| "TEMP HI" light in PRV switch means | Hot air downstream of pre-cooler |
| "TEMP HI" in AUTO results in | Level 1 Alert (amber) PRV closes ISO valves used to run pack |
| "TEMP HI" in MANUAL results in | Red Level 3 Alert No Auto features. Manually close PRV IAW QRH |
| "MANF" light means | Hot air outside the manifold |
| "MANF" light in AUTO results in | CAC MANF DECAY CK (level 1) PRV Closes |
| "MANF" light in MAN results in | CAC MANF FAIL (level 3) PRV Closes Requires crew to perform decay check |
| # 1 "MANF" light alone, leak is _____ | Between #1 Engine pod and CAC |
| #1 & 2 "MANF" lights, leak is _____ | Left FWD tunnel, FWD of CAC |
| #2 "MANF" light alone, leak is ___ | Aft of CAC up to #2 engine |
| #3 "MANF" light alone, leak is ___ | Right engine to fuselage, up FWD right tunnel to pack |
| All 3 "MANF" lights, leak is ___ | Inside the CAC |
| All 3 "MANF" lights on, Controller does the following | Performs decay check to isolate problem Turns good systems back on Red "MANF" lights on until sys cools |
| Lower FWD Cargo compartment | Heated, vented, and cooled from SYS 3 |
| Center Cargo compartment | Heated only from SYS 2 |
| Aft Cargo compartment | Heated, vented, cooled from SYS 2 |
| Max Differential Pressure | 9.1 PSI |
| Normal Differential Pressure | 8.6 PSI |
| Max Operating Altitude | 43,200' |
| Pressure Reliev Valves begin to open at __ fully open at __ | 8.76 PSI 9.1 PSI |
| Max Differential Pressure on the ground | .5 PSI |
| Door will not open if pressure reaches | .55 PSI |
| AC Pressurized to ___ when ___ | 100' Below Field Elevation Slats Extended (cleared to configure) |
| Bleeds and Packs come back on during normal takeoff profile at | First Power Reduction |
| If Packs did not come on at first pwr red, then will come on at | 4500' AFE |
| Normal pressurization schedule begins at ___ for emergency return purposes | 5000' AFE |
| Aircraft depressurizes on landing when | Slats Retracted |
| Ditching Switch does these three things | Closes holes, depressurizes, inhibits GPWS and some landing gear warnings |
| Pressurizaition numbers in sequence | <100', 0.5, 0.55, Pwr Red, 4500', 5000', 8.6, 8.76, 9.1, 43,200' |
| "NO ICE DETECTED" light inhibited below | 18,000' |
| "ICE DET SINGLE" means | One lost system, pilot must determine when to turn on AI |
| EAI uses ___ stage air | MID |
| Wing Anti Ice heats | The outer 5 slats |
| Rule of 4s | One bleed source may only support 4 points (Pack=2, AI=1) |
| If you lose 2 bleed sources, one source may power __ points while ___ | 5 Points, while departing icing conditions |
| Eng 2 Anti Ice Duct DUAL shroud leak produces | Level 1 alert, ENG 2 A-ICE DUCT, Ok to use |
| Eng 2 Anti Ice Duct SINGLE shroud leak produces | Level 1 alert SEL ENG 2 AI OFF |
| If SINGLE shroud w/leak and valve does not close then | Level 3 Alert: ENG 2 A-ICE DUCT Phase ONE required: THROTTLE IDLE |
Created by:
cakorps