LV12 Revision Word Scramble
|
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
| Question | Answer |
| To allow the outer driven wheel to rotate faster than the inner one, the transmissions is fitted with: | a differential |
| To allow for changes in the propshaft length due to suspension movement: | a sliding joint is fitted |
| Which of the following clutch components is connected to the gearbox input shaft? | The centre plate splines |
| A clutch has an excessive amount of 'free play'. This could | make it difficult to disengage the clutch |
| The component which transmits the drive between the input shaft and the main shaft in a RWD three shaft manual gearbox is the: | lay shaft |
| Which of the following is a likely cause of clutch slip? | Not enough clutch free play |
| The overall gear ratio of the transmission is calculated by: | multiplying the gearbox ratio by the final drive ratio |
| A detent ball and spring mechanism is often used to : | lock the selector shafts in position |
| A 'live' rear axle arrangement: | combines the differential and final drive in a rigid casing |
| In a manual gearbox the purpose of the interlock mechanism is to: | prevent two gears being selected at the same time |
| A coil spring clutch is: | heavier and less suitable to high engine speeds than a diaphragm clutch |
| In a four-speed constant mesh gearbox, the gears on the output shaft are always: | free to rotate on the output shaft |
| A damaged gearbox interlock mechanism could allow: | the drive to select reverse when driving |
| A customer complains of a 'crashing sound' when engaging 3rd, the most likely fault is: | worn 3rd gear synchromesh |
| In a hypoid final drive unit the: | pinion centre is offset to the centre line of the crown wheel |
| A vehicle produces a loud knocking sound from the front during very sharp left hand turns. The most likely fault is a: | Badly worn constant velocity joint |
| A constant velocity joint is used: | in a front wheel drive shaft |
| The typical final drive gear ratio for a passenger car is: | between 3:1 and 4:1 |
| Which type of bearing is normally used in a semi-floating hub arrangement: | Taper bearing |
| Difficulty in engaging gears is most commonly cause by: | a worn gear linkage |
| To prevent two gears engaging at the same time the gearbox is fitted with: | an interlock mechanism |
| Multi-plate clutches are often used when the flywheel diameter is limited and: | the engine produces high torque |
| Wheel bearings are usually lubricated with: | grease |
| A clutch emits a bearing whine which disappears when the clutch pedal is depressed, this may be caused by: | a defective clutch release bearing |
| A worn rear wheel bearing is likely to make: | a humming noise |
| Which of the following is likely to produce clutch judder? | Worn centre plate |
| Which RWD rear axle hub arrangement is usually fitted to light vehicles? | Semi-floating type |
| Which of the following faults will affect the way the car drives? | Clutch slipping |
| The force of a diaphragm clutch exerts on a fiction plate: | remains constant with friction plate wear |
| Which of the following components is part of the clutch release mechanism? | The clutch cable |
Created by:
mikewj