FF Chapter 7 Word Scramble
|
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
| Question | Answer |
| What is the NFPA standard for on rope | NFPA 1983 |
| What rope constructionis used for life safety rope | Block and creel construction |
| What is required for manufacturers to provide according to NFPA 1983 | Proper use Inspection procedures Maintenance procedures |
| What must be completed in order to be reused in life safety situations | No abrasions or visible damage No exposure to heat/direct flame No exposure to any impact load No exposure to chemicals |
| How can impact posing be detected | It cannot |
| When should you remove a life safety rope from service | Subjected to impact load Fails inspection |
| What must be done if you downgrade life safety rope to utility rope | Must be permanently altered so it cannot be mistaken for life safety rope |
| What are some examples of synthetic fibers | Polypropylene Nylon Kevlar Polyester Polysteel Spectra |
| What is a disadvantage of synthetic rope | Will melt when exposed to heat |
| What are some advantages of synthetic rope | Resistant to mildew, rot, mold, water, shrinkage Longer life span Lightweight yet strong Easy to maintain |
| What are some natural fiber materials | Manila Hemp Sisal Cotton |
| What are some disadvantages to natural fiber ropes | Prone to mildew and mold Deteriorated when exposed to chemicals Burns when in contact with embers/flames |
| What are some advantages of natural fiber rope | Resistant to sunlight Chars rather then melts when exposed to heat |
| How is kernmantle rope constructed | Inner core of straight running fibers with a sheath of braided fibers |
| What percentage of strength does the inner core of a kernmantle rope hold | 75 |
| What is the covering of a kernmantle rope for | Increase ropes stretch resistance and pod characteristics Protects core from abrasions/contamination |
| What is a dynamic rope | One that stretches under load |
| What is a static rope | One that resists stretching under a load |
| What is elasticity a disadvantage for | Trying to raise or lower a heavy load |
| What stretch rate can static ropes have | 10% extension with 10% of the ropes maximum load applied |
| How is laid rope constructed | Twisting fibers together to form a strand and then twisting several strands together to form the rope |
| What is a disadvantage of laid rope | Susceptible to abrasions and other physical damage Any damage immediately affects the ropes strength |
| What is an advantage of laid rope | Easy to inspect |
| How is braided rope constructed | Uniformly intertwining rope together in a diagonally overlapping pattern |
| What is an advantage of braided rope | Less likely to twist |
| What is a disadvantage of braided rope | Load bearing fibers are vulnerable |
| How is braided rope constructed | Braided core with a braided outer sheath |
| What is an advantage of braid on braid rope | Very strong Half strength in the core and half in the sheath |
| What is a disadvantage of braid on braid rope | Does not resist abrasions well Sheath May slide along the inner core |
| When should rope be inspected | After every use and at least once a year |
| What should be documented on rope logs | Inspections Impact loads |
| What should happen to ropes with a soft spot | Inspect outer sheath, if sheath damaged core damage is likely |
| How should rope be inspected | Slight tension should’ve placed on rope |
| What should you look for when inspecting kernmantle rope | Irregularities Foul smells Discoloration Roughness Abrasions Deterioration Fuzziness |
| What should happen rope is excessively fuzzy | Removed from service |
| How should laid rope be inspected | Untwisted is that all surfaces are exposed |
| What should happen if mildew is found on rope | Cleaned then reinspected |
| What should you look for when inspecting synthetic rope | Soft, crusty, stiff, or brittle spots Cuts, nicks, or abrasions Dirt or grease Excessive stretching Chemical damage |
| What should you look for when inspecting natural rope | Ruptured fibers Powdering between strained Dark spots/discoloration Swollen areas Rust spots Accumulation of dirt/ grease Rot or mildew |
| What can occur if a rope has rot | Can spread quickly to ropes around |
| What should be done if rope is discovered to have rot | That rope and any surrounding rope should removed, cleaned, and reinspected Area holding rope should be cleaned an aired out |
| What should you visually inspect braid braid rope for | Heat sears Nicks Cuts |
| What can a shrunken diameter indicate | A break in the core |
| What should are some things to doin order to maintain a good rope | Avoid abrasions and wear Avoid sharp angles, bends, and knots Protect ends Avoid sustained loads Avoid rust/chemicals Reverse ends occasionally Don’t walk on rope |
| How can rope become worn or have abrasions | Constant apparatus vibration Compressed when stored Chafing or dragging over materials |
| How much can strength be reduced from sharp angles, bends and knot damage | Upto 50 percent |
| How can you protect rope ends | Whip or tape cut ends |
| What can occur if a rope is subjected to a sustained load | Can break well below it’s breaking limit |
| What damage is done by walking on rope | Dirt and debris can be grinded into rope Brussels the strands from compression |
| Of rope is contaminated how should it be cleaned | With a stiff bristled brush |
| How should you wash synthetic rope | A mild detergent and like warm water |
| How are some ways you can wash synthetic rope | Hand washing Rope washing device Normal washing machine |
| What is a disadvantage to a rope washing device | Cannot be used with a detergent Doesn’t address deeper cleaning |
| How should rope be placed in a washing machine | Inside of a mesh bag |
| What settings should be used in a washing machine | Coldest wash/rinse temperature available No center agitator |
| What should be done after rope has been washed | Dry immediately |
| How can rope be dried | Hose drying rack Suspended in a hose tower Loose coil in a hose dryer |
| How should you never dry rope | Placed near a heat source In direct sunlight |
| How should natural fiber rope be cleaned | Wipe or gently brush the rope |
| What should you not use to wash natural fiber rope | Water |
| What should you do if natural fiber rope comes in contact with water | Immediately dry it |
| How should rope be stored | In a rope bag Not in the same compartments as chemicals/fuels Not in the same compartment as gasoline tools Wear exhaust doesn’t accumulate |
| What must be included on a rope log | Product/identification label Manufacturer instruction on use/maintenance/inspection Purchase date Impact loading incidents Inspections |
| How is flat webbing constructed | Single layer of material |
| What webbing is preferred for rescue applications | Tubular webbing |
| What is the working end of a rope | Part used to tie a knot |
| What is the running part of a rope | Free end used for hoisting/pulling |
| What is the standing part of a rope | Section between working and running part |
| What is used to prevent failures in knots | An overhand safety knot on the working end of the rope |
| What is a bight | Rope bent back on itself with parellel sides |
| What is a loop | A full twist in the rope |
| What is a round turn | Further bend one side a loop |
| What is the principal use of a clove hitch | Attach rope to an object |
| What is a common use for a figure eight | Stopper knot |
| What is a figure eight bend used for | Tie ropes of equal diameters together |
| What is a figure eight follow through used for | Securing objects |
| What is a water knot used for | Joining two pieces of webbing |
| What cannot be hoisted according to osha | An air cylinder |
| What are rag lines used for | Prevent tools being hoisted from spinning or snagging |
| What is a carabiner | Snap link made from aluminum, steel, or titanium with a spring or screwed gate |
| What is the purpose of a carabiner | Connect ropes to other mechanical gear |
| What is a pulley used for | Create mechanical advantage or a change in direction |
| What should be done when hoisting materials | Make sure personnel are clear |
| What rope has been traditionally used to establish a perimeter line | Utility rope |
| What is the purpose of a search line | Allow members to remain in contact with each other Means of finding an exit route |
| What is used to stabilize an object | Rope or webbing |
| How should you go about stabilizing an object | Secure rope/webbing to an anchor then tocthe object needing stabilization |
| What should you do before tying a rope to an object needing stabilizing | Ensure strength of anchor and rope/webbing Ensure knots are tight and safety knots applied Ensure Attachment points are secure Ensure personnel clear from stabilizing line |
Created by:
Kab731