ATC Review
Quiz yourself by thinking what should be in
each of the black spaces below before clicking
on it to display the answer.
Help!
|
|
||||
---|---|---|---|---|---|
show | seperating traffic and issuing safety alerts
🗑
|
||||
show | too close to terrain or obstruction
🗑
|
||||
show | when an operational advantage is gained
🗑
|
||||
Aircraft using the code name "Garden Plot" have priority only if what occurs? | show 🗑
|
||||
Transfer control responsibility at a prescribed or coordinated location, time, fix, or altitude only after doing what? | show 🗑
|
||||
When may you omit time, fix, or altitude during radio communications? | show 🗑
|
||||
When may an aircraft be cleared below the MEA using nonradar procedures? | show 🗑
|
||||
show | 1) depart fix at specified time, 2) arrive at specified time, 3) hold until specified time, 4) change altitude at specified time
🗑
|
||||
show | 10 miles
🗑
|
||||
show | 5 miles
🗑
|
||||
What is the phraseology to clear UAL16 on a 20-mile arec north of Miami VORTAC? | show 🗑
|
||||
show | 1) type of approach to expect, 2) radar vectors to final approach course, 3) current WX if ceilings are below 1,000 (or highest ceiling is below)
🗑
|
||||
Where may Specvial VFR operations be authorized? | show 🗑
|
||||
show | when verbally requested
🗑
|
||||
The word "______" should be used only when expeditious compliance is required to avoid a(n) ______ situation. | show 🗑
|
||||
When NOT covered in an LOA, IFR flight progress data must be forwarded within ____ minutes before the aircraft will enter the receiving facilities area? | show 🗑
|
||||
show | 10 minutes
🗑
|
||||
show | 3 minutes
🗑
|
||||
show | 5 minutes
🗑
|
||||
Separate aircraft on oppositie course with vertical separation from _____ minutes before until _____ minutes after they are estimated to pass? | show 🗑
|
||||
Consider an altitude readoiut valid when it varies less than ____ feet from the pilot-reported altitude. | show 🗑
|
||||
SVFR flight may be approved only if arriving and departing IFR aircraft are ______. | show 🗑
|
||||
show | 4 miles
🗑
|
||||
When may aircraft be cleared through Class G airspace? | show 🗑
|
||||
When applying 5 minutes longitudinal separation for aircraft climbing/descending through the altitude of another aircraft, the aircraft involved CANNOT be separated by more than ______ feet when the altitude change started. | show 🗑
|
||||
An aircraft below FL600 on a direct course 48 miles from a NAVAID would be protected by how many miles on each side of its route? | show 🗑
|
||||
show | 10 miles
🗑
|
||||
Where a higher altitude is required because of a new MEA and NO MCA is specified, when must a pilot be cleared to climb? | show 🗑
|
||||
show | 20 miles DME or 10 minutes
🗑
|
||||
show | 1303 (3 minute rule)
🗑
|
||||
When the leading aircraft is descending or the following aircraft is climbing through the altitude of another aircraft, the minimum DME separation is _____ miles? | show 🗑
|
||||
show | the aircraft previously at that altitude has reported leaving the altitude
🗑
|
||||
When may an aircraft be cleared below the MOCA? | show 🗑
|
||||
What two actions must be taken when clearing aircraft below the MEA while applying radar procedures? | show 🗑
|
||||
show | 3 minutes or 5 miles
🗑
|
||||
At a nonapproach control tower, what minima may be used to separate a departure from an arrival? | show 🗑
|
||||
What is always included in an abbreviated departure clearance? | show 🗑
|
||||
show | Aircraft ID and type, nature of the emergency, and pilot's desires
🗑
|
||||
show | at least 5 minutes before the aircraft is estimated to reach clearance limit
🗑
|
||||
show | as soon as possible or at least within 5 minutes before the aircraft reaches the fix
🗑
|
||||
Successive departures with courses that will diverge 45 minutes within 5 minutes after takeoff. When can the 2nd aircraft be released? | show 🗑
|
Review the information in the table. When you are ready to quiz yourself you can hide individual columns or the entire table. Then you can click on the empty cells to reveal the answer. Try to recall what will be displayed before clicking the empty cell.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
To hide a column, click on the column name.
To hide the entire table, click on the "Hide All" button.
You may also shuffle the rows of the table by clicking on the "Shuffle" button.
Or sort by any of the columns using the down arrow next to any column heading.
If you know all the data on any row, you can temporarily remove it by tapping the trash can to the right of the row.
Embed Code - If you would like this activity on your web page, copy the script below and paste it into your web page.
Normal Size Small Size show me how
Normal Size Small Size show me how
Created by:
davidhub