Question | Answer |
Don’t ____________ anyone while they are working on the lathe. | distract |
Never use the lathe without ___________________. You can get it by getting 100 on your written test, 100 on your practice test, and having a partner. | permission |
A _____________________ should be worn to protect your eyes when operating a lathe. | face shield |
Long hair should be pulled back and loose clothing should be tucked in to keep from being ________________ in the lathe. | caught |
_____________ wear a necklace or dangling jewelry when operating a lathe. | never |
No one should stand near the operator or ___________ to someone using a lathe. | talk |
When a safety shield is used, it must be kept ______________ so the operator can see through it clearly. | clean |
The wood that is being turned must be in good condition and free from any _________________. | defects |
If the wood has been glued, it should set up for at least 24hrs and be firmly ______________ before it is turned. | bonded |
The material must be __________________ and fastened firmly in the lathe. | centered |
Adjust the tool rest so it is slightly above the center and as close to the material as possible without ___________________ it at any point. | touching |
Rotate the ______________________ before turning the power on. Make sure the stock does not hit the tool rest. | hand wheel |
The wood turning chisels and gouges must be in good condition and _________________. | sharp |
Only use chisels and gouges that are specifically designed and manufactured for ____________________________. | wood turning |
The ______________ of the lathe should be adjusted for the type of material and the size of the material that is going to be turned. | speed |
The lathe should be turned off immediately if it begins to ______________. | vibrate |
The lathe must be completely ________________ before any adjustments or measurements are made. | stopped |
Dull tools are more _______________________ than tools that a kept sharp. | dangerous |
The cutting tool must be held firmly with _______________________. | both hands |
Whenever possible, the cut should be started in the _________________ of the stock. | middle |
The cut should be shallow, smooth and even. A cut that is too ____________ is dangerous. | deep |
Before any sanding or polishing operation, the ______________________ must be removed. | tool rest |
Fold the ____________________ neatly so it won’t get caught in the turning lathe or the material. | polishing rag |
Use a _________________ speed for sanding or polishing. | slow |
Do not use the lathe until you fully _______________ how to use it correctly and safely. | understand |