Lecture 3 Hangman

 
hangman
                                       
                                                                                                                       
 
 

 
 

 
 

 
Teachers and Webmasters: Copy-and-paste the HTML code below into your web page to have the Hangman game displayed on your web page.


 
www.eapps.com




Copyright ©2001-2008 John Weidner All rights reserved.
About -  Terms of Service -  Privacy Statement



Flap 1 Flap 2
T/F Compression causes herniation.  FALSE!  
Farfan produced herniation with 15 degrees of bending. What was significant about this study that makes it invalid?  There were no posterior elements! (Pedicles, lamina, etc.) Because you can't get 15 degrees of bending without removing those!  
T/F In Roaf''s studies bulge is always on the concave side.  TRUE  
T/F Denucleation decreased bulging is Roaf's studies.  FALSE!! Denucleation INCREASED bulging!  
Define SHEAR stress:  The intensity of force parallel to the surface on which it acts  
T/F A straight shear across a disc is a common injury.  FALSE! Failure forced must be too high for this to occur!! VERY RARE!!  
Define TORSION:  A type of load applied by a COUPLE of forses about the long axis of a structure.  
What is the other name for torsional loading?  TORQUE  
What kind of stresses are caused by torsional loading?  Shear, compression and tension  
At what angle is shear stress applied to a structure under torsional loading?  90 degrees  
Is shear stress during torsional loading higher at the CENTER or the PERIPHERY?  PERIPHERY  
How is COMPRESSION distributed during torsional loading?  45 degress to the axis in the OPPOSITE direction of the applied force  
How is TENSION distributed during torsional loading?  45 degress to the axis in the same direction as the applied force  
T/F A normal disc can handle torsion better than a degenerated disc.  FALSE! Normal discs had a 25% higher failure rate with torque!  
T/F Large discs have a larger torsional strength.  TRUE  
What is the average faulure anlgle for torsional strain?  15 degrees  
T/F The first experimental disc "prolapse" was performed by Adams and Hutton and was featured in Spine magazine.  TRUE  
In the experiment by Adams and Hutton, the spine was hyperflexed and laterally bent and then a sudden compressive force was applied. What side of the spine was the prolapse observed?  CONVEX  
Adams and Hutton found a pattern to failures. What discs, degeneration grade, and in what age group were discs most likely to fail under their methods?  L4 and L5, Grade 2 degeneration, 40-49 YOA  
T/F Most herniation/prolapse patients present with a precipitating traumatic event.  FALSE! Most do NOT had a hx of traumatic event  
When Adams and Hutton altered their experiment by varying loads at 40 loads/minute, what happened?  6 or 49 prolapsed, 35 end plate failures/vert. collapse  
What did Adams and Hutton's 40 loads/minute variation prove?  That repetition is probably NOT a mechanism for gradual prolapse  
Define VISCOELASTICITY:  The physical properties of a structure that document its time-dependent behavior  
Define CREEP:  A viscoelactic material defoms WITH TIME when it is subjected to a CONSTANT load.  
T/F Zararian's studies on COMPRESSION CREEP showed that normal discs creep more slowly than degenerated discs - reach maximum deformation after a longer period of time.  TRUE  
T/F As a disc degenerates, it loses its capacity to attenuate shocks and to distribute load uniformly over the entire endplate.  TRUE  
Define Hysteresis:  A phenomenon associated with energy loss exhibited by viscoelactic materials when they are subjected to loading and unloading cycles  
Which has a greater hysteresis: higher or lower load?  HIGHER  
At the same load, which would have the smallest hysteresis: a very young disc or a middle-aged disc?  Middle-aged disc (doesn't absorb shock as well)  
Upon a second loading, is there an increase or decrease in hysteresis?  DECREASE! There is less shock protection with repetitive loads!!  
In epidemiological studies on HYSTERESIS by Kelsey and Hardy, who had an increase incidence because of repetitive axial loading?  Motor vehicle drivers - especially truck drivers  
Define FATIGUE:  The process of the growth of cracks in structures subjected to repetitive load cycles with loads LESS than failure load.  
T/F Repetitive load cycles less than failure load will NEVER cause a structure to fail.  FALSE! What a fatigue crack reaches a certain sive the stress in the rest of the structure becomes so high that the structure fails  
Although Brown's fatigue experiments were performed IN VITRO and during sleep the body can repair and regenerate, his experiments may still be clinically significant. Why?  Because the repair and regeneration of IVDs is thought to be low and because IVDs are avascular after 25YOA